If you repair Dell LCD Monitor (E173Fpb and etc) you would know that most of the power blinking problem was due to a shorted C5707 transistor. This transistor is located nearby the high voltage transformer and when it have dry joints, the push pull transistor C5707 would go shorted. If you want to replace this transistor, you have to replace the other one also (because it comes in a pair to switch the high voltage transformer)
for any kind of information about Transistor C5707 contect with me, i will solve your problem.
Popular Posts
-
If you repair Dell LCD Monitor (E173Fpb and etc) you would know that most of the power blinking problem was due to a shorted C5707 trans...
-
This Ultra Small Universal CCFL 4 Lamp 12-30V high-voltage board LCD Inverter for 17-24" LCD Monitor. It is a DC 12V to 5V step ...
-
Universal CCFL Inverter 10-28V 4 Lamp LCD Monitor high-voltage board for 15" to 22" LCD Monitor. Feature: 10-28V high-voltage...
Ultra Small Universal LCD Inverter Card
This
Ultra Small Universal CCFL 4 Lamp 12-30V high-voltage board LCD Inverter for 17-24" LCD Monitor.
It is a DC 12V to 5V step down converter, with USB mounting holes, maximum output current 3.6A, conversion rates up to 96%, fever is very low, it can waterproof and short-circuit protection, it is very suitable for car power supply.
Feature:
- for 17" to 24" LCD Monitor
- Voltage: 12-30V
- Size: 9 x 4.3 cm
- Interface: VCC, VCC, ON/OFF, ADJ, GND, GND
- The Red and Black wires may be improperly reversed on some inverters. Make sure you pay close attention to the correct polarity markings on the back side of the circuit board.
- This inverter operates on 10 to 28 volts DC. It also requires a turn on voltage of 3.3 to 12 volts(Yellow Wire ON/OFF).
This Artical by-- PASHA LABS
Univesal Inverter
Universal CCFL Inverter 10-28V 4 Lamp LCD Monitor high-voltage board for 15" to 22" LCD Monitor.
Feature:
- 10-28V high-voltage board
- for 15" to 22" LCD Monitor
- Voltage: 10-28V
- Size: 3.5 x 13.4cm
- Red Wire: Vin+
- Yellow Wire: ON/OFF, ADJ
- Black Wire: GND
- The Red and Black wires may be improperly reversed on some inverters. Make sure you pay close attention to the correct polarity markings on the back side of the circuit board.
- This inverter operates on 10 to 28 volts DC. It also requires a turn on voltage of 3.3 to 12 volts(Yellow Wire ON/OFF).
- The turn on voltage can be triggered by attaching one of the yellow wires to the positive side of your power supply. (PASHA LABS)
Subscribe to:
Posts (Atom)